Failure analysis and diagnostic guides for industrial components
Increasing the return stroke of the Heidenhain L=9M310-130-05 ball screw leads to an increase in the positioning error. The defect is caused by loss of…
In-depth forensic analysis of chain drives in the Benelux manufacturing industry. Learn how to detect chain stretch, misalignment and lubrication problems in a timely manner…
The Allen Bradley 871C-DT10NP30-U2 coupling failed after 14,500 hours due to misalignment, torque overload and fatigue. This analysis identifies root causes and proposes practical solutions…
Analysis of the failure of a set of screws in the transmission module identified three main causes: increased cyclic load, inaccurate fit and excessive speed.…
Gear tooth pitting and spalling in SKF S7014 ACEGA/HCP4A gears are caused by lubrication contamination, misalignment, and material fatigue. This article provides a systematic root…
Introduction: The warning signal that triggers research Cavitation in pumps is a common phenomenon that can lead to catastrophic failures if not detected in time.…
An ABB RN13076101307610 coupling was analyzed to identify the root causes of a failure. The main causes are torque overload, incorrect alignment and lubricant degradation.…
Coupling failure modes such as misalignment, torque overload, and fatigue cracking are analyzed using real-world evidence. A systematic root cause investigation identifies the primary causes…
VICKERS 02-322621 hydraulic cylinder leakage can occur due to contamination, deviations or pressure peaks. Carrying out a systematic analysis and taking recommended actions will ensure…
This technical article investigates the root cause of pitting and spalling failures in gear teeth of Festo VPEV 1/8 reducers. Through analysis of evidence such…
