Expert articles on root cause analysis: failure investigation and prevention strategies.
A collapse of the SKF 32028X filter element leads to differential pressure and contamination peaks. The causes lie in differential pressure overloading, insufficient cleaning, and…
A shaft key failure requires an in-depth analysis of the causes. The failure of the VICKERS key 02-102539 has been identified as the main cause,…
Explosion loss spherical roller bearings arose due to high temperatures and vibrations. Maintenance includes measuring vibration and temperature, as well as using high-quality components. Refer…
KSA25EZ1 filter element collapse is caused by contamination, high pressure and defects in the bypass system. Thorough analysis and proactive maintenance are essential to prevent…
Overheating of a servo motor is a warning signal that there is an impending risk of failure. Through a systematic root cause analysis, causes such…
The overheating of an SKF FY20TF servo motor was analyzed to identify the root causes. Sizing errors, poor duty cycle estimation and cooling system failure…
An increase in temperature, abnormal vibrations and chain elongation indicate a critical failure. Root cause analysis shows that insufficient maintenance is the main cause. Replacing…
Pump cavitation leads to reduced efficiency, vibration, and mechanical failure. This article investigates NPSH analysis, root causes, and diagnostic vibration signatures for the Siemens 6SN1123-1AA00-0CA2…
The Siemens thermal relay 6ES7 361-3CA01-0AA0 may experience false trips due to ambient temperature, load profile, or design errors. A rigorous analysis and corrective actions…
Shaft key failure in FIBRO 2480.21.00150.063 couplings is often due to design stress mismatch, improper fit tolerance, or fatigue. This analysis provides a practical checklist…
Introduction The burning of a solenoid valve coil is a common problem in industrial automation systems, especially in environments with high operating loads and elevated…
A DANFOSS OMP1001510622 bearing failed prematurely after 14 000 hours. The analysis identifies causes such as improper mounting and contamination. Corrective measures and rigorous follow-up…
