Root Cause Analysis: Belt Stretching and Gear Wear in Transmission Systems
PLEASE SELECT TWO DISTINCT LANGUAGES
Cause Analysis
Expert articles on root cause analysis: failure investigation and prevention strategies.
Root Cause Analysis of Hydraulic Cylinder Seal Failure: Contamination vs. Misalignment vs. Pressure Peaks
Seal failure on a Heidenhain hydraulic cylinder can be caused by contamination, misalignment, or pressure spikes. This article proposes a practical methodology for its diagnosis…
Analysis of the causes of blocked pneumatic valves: contamination, moisture and wear
Blocking pneumatic valves can occur due to contamination, moisture and poor lubrication. Systematic cause research and preventive maintenance are crucial. Further information can be found…
Root Cause Analysis: Why Transmission Belts Overheat — 5 Common Causes and Diagnostic Flowchart
Transmission belt overheating is a critical failure mode that can be traced to excessive tension, misalignment, contamination, and environmental factors. This article provides a forensic…
Root Cause Analysis: Filter Element Collapse at HYDAC 908735
Filter elements such as the HYDAC 908735 can collapse due to pressure increase, contamination and insufficient maintenance. A systematic investigation and preventive measures are essential.…
Analysis of tooth swirl and tooth calcification in gear units: Lubrication, alignment and material fatigue
Tooth swirling and tooth calcification in the Allen Bradley 700-P800A1 are the result of inadequate lubrication, elevated temperature and improper alignment. The analysis shows a…
Root Cause Analysis of Shaft Nail Failure: Design Stress, Fit Tolerance and Fatigue under Cyclic Loading
A failure in the shaft nail of the Siemens 3WX3653-1JBOO motor was investigated using root cause analysis. Causes include improper design, incorrect fit tolerance, and…
Root Cause Analysis: Why Drive Belts Overheat – 5 Common Causes and Diagnostic Flow
Introduction: The symptom that triggers the investigation A drive belt that consistently overheats can be a sign of a systemic problem. At a production workshop…
Root Cause Analysis of Oil Leakage in a Gearbox: Seal Selection, Ventilation and Assembly Errors
An oil leak in the REXROTH 4WS2EM10-52/45B11ET210K31EV gearbox can be caused by errors in seal selection, ventilation problems and improper assembly. This article examines the…
Analysis of Encoder Signal Loss: Cable Shielding, EMI and Connector Degradation in Hydraulic Pumps
This article analyzes the signal loss of an encoder on a VICKERS VVP-50-SBR-M-30-CD2-(04)-BK-10 pump. The focus is on the influence of cable shielding, electromagnetic interference…
Root Cause Analysis of Hydraulic Cylinder Seal Failures: Contamination, Misalignment and Pressure Spikes
Introduction Continuous operation in manufacturing environments demands maximum reliability from hydraulic systems. A common, but critical, failure is oil leaks in hydraulic cylinders. This seemingly…
Cause of transmission belt overheating: 5 common causes and diagnostic flowchart
Overheating of transmission belts in production machines often leads to unplanned downtimes. The FIBRO 2052.70.040.050.050 is a critical component in the Benelux industry. The lifespan…