Expert articles on root cause analysis: failure investigation and prevention strategies.
In-depth forensic analysis of chain drives in the Benelux manufacturing industry. Learn how to detect chain stretch, misalignment and lubrication problems in a timely manner…
The Allen Bradley 871C-DT10NP30-U2 coupling failed after 14,500 hours due to misalignment, torque overload and fatigue. This analysis identifies root causes and proposes practical solutions…
Analysis of the failure of a set of screws in the transmission module identified three main causes: increased cyclic load, inaccurate fit and excessive speed.…
Gear tooth pitting and spalling in SKF S7014 ACEGA/HCP4A gears are caused by lubrication contamination, misalignment, and material fatigue. This article provides a systematic root…
Introduction: The warning signal that triggers research Cavitation in pumps is a common phenomenon that can lead to catastrophic failures if not detected in time.…
An ABB RN13076101307610 coupling was analyzed to identify the root causes of a failure. The main causes are torque overload, incorrect alignment and lubricant degradation.…
Coupling failure modes such as misalignment, torque overload, and fatigue cracking are analyzed using real-world evidence. A systematic root cause investigation identifies the primary causes…
VICKERS 02-322621 hydraulic cylinder leakage can occur due to contamination, deviations or pressure peaks. Carrying out a systematic analysis and taking recommended actions will ensure…
This technical article investigates the root cause of pitting and spalling failures in gear teeth of Festo VPEV 1/8 reducers. Through analysis of evidence such…
A customer reported recurring failures on the FIBRO 246.7.040.050 conveyor belt. The cause was an imbalance between the crown, idler alignment and load distribution. This…
Chain and pulley wear in machine tools is a common problem that requires precise analysis. This article presents an investigation of the root causes and…
Deflection of the conveyor belt occurs due to the absence of a ring, incorrect centering of the idlers and insufficient level of lubrication. The use…
